Hardware in Tuning

Items 1 to 16 of 17
Sort by:

Jazz up your cars with our chrome axles. Nickel-coated steel axles create a finished look for race cars – plus the slick surface decreases the amount of friction produced. 1/8" x 70 mm.

$12.95

Use this self-lubricating material for axles. Lighter weight and less friction mean greater speeds. Cut these two-foot axles to desired lengths using the Precision Metal Saw, sold separately.

$2.25

Cut your dragster’s axle weight in half by using aluminum instead of steel! Buy these 1/8" diameter axles precut, or cut your own from our three-foot lengths. Use the Precision Metal Saw (sold separately) to cut axles to desired lengths.

Options Available
From $0.85

These low-profile rings are placed on the outside of shell car bodies to hold the axle in position. 1/8" inside diameter.

$7.50

This solid brass axle material is an alternative to steel for CO2 dragsters, mousetrap vehicles, and other model vehicles. When used with brass bushings, this material has ultra-low friction to help you increase speed.

Rods are 12" long – cut them to length using a metal saw, sold separately.

Options Available
From $2.15

This brass axle material is a lightweight alternative to steel for CO2 dragsters, mousetrap vehicles, and other model vehicles. When used with brass bushings, this material has ultra-low friction to help you increase speed.

Rods are 12" long – cut them to length using the Tubing Cutter, sold separately.

Options Available
From $2.15

These brass washers help reduce friction between the wheel and the dragster body. 1/8" inside diameter.

$4.40

These tubes are laminated and feature a Mylar plastic coating over paper for durability and less friction. Inside diameter 5/32" (0.156") fits 1/8" axle rods. Outer diameter is 0.171". Available in lengths of 2-3/8" or 8". The 8" tubes may also be used as launch lugs. Ten per package.

Options Available
From $1.95

For use with shell-type dragsters and other applications.

$29.95

These lightweight spacers can be placed between the wheels of shell cars and can also function as friction-reducing axle bushings. 1/4" outside diameter x 1" length.

$5.45

The ultimate in reducing rolling friction of dragsters. Inside diameter of bearing is 1/8", allowing it to be pressed onto 1/8" axles. Outside diameter is 3/8", width is 5/32".

$5.45

Use this self-lubricating material for axles. Lighter weight and less friction mean faster speeds.

$7.65

Use these lightweight, naturally slick nylon washers to try to get that little bit of extra speed from your dragsters. 1/8" inside diameter.

$4.95

Use screw eyes to keep dragsters on the track with monofilament line.

$6.95

Use the strength of steel to mount your dragster’s wheels!

Options Available
From $2.25

Looking for a way to increase the speed and performance of your dragster? Try Pitsco’s Ultimate Axle Bushings – the ultimate in friction reduction.

These bushings fit snugly into the drilled axle hole, providing a slick, flat outer surface that will rub against the wheel hubs – similar to the function of washers but even better.

The interior of the axle bushing has been engineered to provide only a small amount of surface area that is in direct contact with the axle. In fact, these bearings provide a 94% reduction in the average surface bearing area – the area where friction is produced.

Ultimate Axle Bushings – another innovation from your friends at Pitsco! Flange diameter is 0.313". Fits snugly in a 0.25" hole.

Options Available
From $1.10
First PagePrevious Page
12
Next PageLast Page